The 6 Way Powerboard with over-current protection is equipped with a circuit breaker, which will safely shut off all power in the event of overloading. After eliminating the overload it can be reset by switching the power off and switching the power point back on.
- Ideal for computer hardware, electrical equipment and domestic appliances
- 6 Outlets
- Overload protection
- 1m cord length
- Input: v 240Volt / 50Hertz
- Max.: 10Amps
Use only with a correctly wired regular power point (240 Volt Max. Load 10Amps) and ensure you have a good earth connection.
Note: This power board does not have surge protection and will not protect your equipment if lightning directly strikes the house, electrical services or antenna. The over-current protection will not offer protection if there is a sustained over voltage condition caused by a fault in the mains power distribution system.
Do not use outdoors or in wet locations and use only with a correctly wired power point. If in doubt consult a qualified electrician.
Dust or wipe clean with a cloth dampened with water once a week. Be sure not to leave water spots on the surface. These water spots will dry and could possibly leave permanent marks.
Clean stains/spots using the following steps: Dampen a soft cloth with a mixture of hot water and liquid dishwashing detergent. Wring the cloth as much as possible to remove excess liquid. Rub the surface lightly in a circular motion. Dry the surface immediately with a clean, soft towel.